This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
en:ztex_boards:ztex_fpga_boards:sd_cards_on_series_2_fpga_boards [2014/07/21 13:03] – stefan | en:ztex_boards:ztex_fpga_boards:sd_cards_on_series_2_fpga_boards [2016/09/14 19:45] (current) – stefan | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== SD card support on Series 2 FPGA Boards ====== | + | ====== SD card support on FX2 based Series 2 FPGA Boards ====== |
+ | ZTEX uses the FX3S on its FPGA Boards. These boards have native SD card support (including SDIO). | ||
- | By introduction of [[http:// | + | On FX2 based based Series 2 FPGA Boards |
+ | |||
+ | This page described how this is done and how firmware support is activated. This is explained best by an example: | ||
A SD card is connected to an [[http:// | A SD card is connected to an [[http:// |