Differences

This shows you the differences between two versions of the page.

--- en:software:fwloader [2017/03/22 21:35] – [Ordered options] stefan
+++ en:software:fwloader [2022/09/09 10:10] – [Ordered options] 87.177.182.45
@@ Line 35: / Line 35: @@
 | -i              | Print device info |
 | -ru             | Reset EZ-USB |
-| -uu <ihx file>  | Upload Firmware to EZ-USB |
+| -uu <firmware file>  | Upload Firmware to EZ-USB |
 |  The following options require an installed ZTEX Firmware (e.g. by ''-uu <firmware>'')  ||
 | -ii             | Print device info + capabilities |
@@ Line 42: / Line 42: @@
 | -il             | Print log messages of FX3 based FPGA Boards |
 | -re             | Disable EZ-USB firmware in nonvolatile memory |
-| -ue <ihx file>  | Upload EZ-USB Firmware to nonvolatile memory |
+| -ue <firmware file>  | Upload EZ-USB Firmware to nonvolatile memory |
 | -ss <sn string>  | Set the serial number, see [[#serial_numbers]] |
 | -su <VID> <PID>  | Set the USB ID's in configuration memory, 0 to load ID's defined by firmware |
@@ Line 50: / Line 50: @@
 | -uf <bitstream> | Upload bitstream to FPGA |
 | -um <bitstream> | Upload bitstream to Flash |
-| -rm             | Disable bitstream in Flash |
+| -rm             | Reset bitstream in Flash |
 | -bs 0<nowiki>|</nowiki>1<nowiki>|</nowiki>A       | Bit swapping for bitstreams: 0: disable, 1: enable, A: automatic detection |
 | -uxf <ihx file> | Upload Firmware / data  to ATxmega Flash |