Differences

This shows you the differences between two versions of the page.

--- en:software:fwloader [2017/03/22 21:35] – [Ordered options] stefan
+++ en:software:fwloader [2023/10/30 17:32] (current) – [Ordered options] stefan
@@ Line 35: / Line 35: @@
 | -i              | Print device info |
 | -ru             | Reset EZ-USB |
-| -uu <ihx file>  | Upload Firmware to EZ-USB |
+| -uu <firmware file>  | Upload Firmware to EZ-USB |
 |  The following options require an installed ZTEX Firmware (e.g. by ''-uu <firmware>'')  ||
 | -ii             | Print device info + capabilities |
@@ Line 41: / Line 41: @@
 | -ic             | Print configuration data and flash info |
 | -il             | Print log messages of FX3 based FPGA Boards |
+| -is             | Print detailed FLASH/SPI info
 | -re             | Disable EZ-USB firmware in nonvolatile memory |
-| -ue <ihx file>  | Upload EZ-USB Firmware to nonvolatile memory |
+| -ue <firmware file>  | Upload EZ-USB Firmware to nonvolatile memory |
 | -ss <sn string>  | Set the serial number, see [[#serial_numbers]] |
 | -su <VID> <PID>  | Set the USB ID's in configuration memory, 0 to load ID's defined by firmware |
@@ Line 50: / Line 51: @@
 | -uf <bitstream> | Upload bitstream to FPGA |
 | -um <bitstream> | Upload bitstream to Flash |
-| -rm             | Disable bitstream in Flash |
+| -rm             | Reset bitstream in Flash |
 | -bs 0<nowiki>|</nowiki>1<nowiki>|</nowiki>A       | Bit swapping for bitstreams: 0: disable, 1: enable, A: automatic detection |
+| -ff 0<nowiki>|</nowiki>1  | Inform the Default firmware whether the FPGA may access Flash memory. 1: FPGA can access Flash (default on FX2 based boards). 0: FPGA will not access Flash (default on FX3 based boards). Note: Changes take effect after restarting the firmware (-ru). |
+| -fu <offset> <file> | Upload user data from file <file> to Flash memory. Start address in bytes relative to user space is given by <offset> and must be a sector boundary. |
+| -fd <offset> <file> <len> | Download <len> bytes of user data from flash to file <file>. Start address in bytes relative to user space is given by <offset> and must be a sector boundary. |
 | -uxf <ihx file> | Upload Firmware / data  to ATxmega Flash |
 | -uxe <ihx file> | Upload data to ATxmega EEPROM |