Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision |
| en:ztex_boards:ztex_fpga_boards:usb_powering [2016/09/15 08:33] – stefan | en:ztex_boards:ztex_fpga_boards:usb_powering [2016/09/15 08:34] – stefan |
|---|
| |
| Whether / how USB powering is supported is listed in the following table | Whether / how USB powering is supported is listed in the following table |
| ^ FPGA Board ^ Power source selection ^ comments ^ | ^ FPGA Board ^ Power source selection ^ comments ^ |
| | [[http://www.ztex.de/usb-fpga-2/usb-fpga-2.16.e.html|USB-FPGA Module 2.16]] | no | USB powering not supported | | | [[http://www.ztex.de/usb-fpga-2/usb-fpga-2.16.e.html|USB-FPGA Module 2.16]] | no | USB powering not supported | |
| | [[http://www.ztex.de/usb-fpga-2/usb-fpga-2.14.e.html|USB-FPGA Module 2.14]] | automatically | USB 3.0 delivers sufficient power for small applications including RAM | | | [[http://www.ztex.de/usb-fpga-2/usb-fpga-2.14.e.html|USB-FPGA Module 2.14]] | automatically | USB 3.0 delivers sufficient power for small applications including RAM | |
| | [[http://www.ztex.de/usb-fpga-2/usb-fpga-2.13.e.html|USB-FPGA Module 2.13]] | by soldering a 0Ω | not recommended because USB 2.0 usually deliver insufficient power | | | [[http://www.ztex.de/usb-fpga-2/usb-fpga-2.13.e.html|USB-FPGA Module 2.13]] | by soldering a 0Ω resistor | not recommended because USB 2.0 usually deliver insufficient power | |
| | [[http://www.ztex.de/usb-fpga-2/usb-fpga-2.04.e.html|USB-FPGA Module 2.04]] | by soldering a 0Ω | USB 2.0 usually deliver insufficient power if RAM is used | | | [[http://www.ztex.de/usb-fpga-2/usb-fpga-2.04.e.html|USB-FPGA Module 2.04]] | by soldering a 0Ω resistor | USB 2.0 usually deliver insufficient power if RAM is used | |
| | [[http://www.ztex.de/usb-fpga-2/usb-fpga-2.01.e.html|USB-FPGA Module 2.01]] | by jumper | USB 2.0 usually deliver sufficient power | | | [[http://www.ztex.de/usb-fpga-2/usb-fpga-2.01.e.html|USB-FPGA Module 2.01]] | by jumper | USB 2.0 usually deliver sufficient power | |
| |
| |
