This shows you the differences between two versions of the page.
en:discussions:invalid_ztex_descriptor [2012/02/20 21:08] – created 98.207.18.114 | en:discussions:invalid_ztex_descriptor [2017/02/04 19:19] (current) – gelöscht stefan | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | <- [[: | ||
- | ====== Invalid Ztex Descriptor ====== | ||
- | |||
- | //, 2012/02/20 20:56 // | ||
- | |||
- | |||
- | |||
- | ~~DISCUSSION~~ | ||
- | Hi, | ||
- | |||
- | I have a 1.11c module and all of the examples in the SDK work well. I am now trying to upload an ihx file that was created outside of the SDK with SDCC but continue to get an Invalid Ztex Descriptor on every attempt to upload it. I read a few of the other posts ie: Reconfigure non-ztex device & USB Device not recognized and followed the suggestions there without much luck. Now I had previously loaded the debug.ihx and that was running, I then reset it with the -ru command, upon which I tried the following | ||
- | |||
- | > sudo java -cp FWLoader.jar FWLoader -c -f -uu myfile.ihx | ||
- | |||
- | Error: Incompatible firmware: Invalid ZTEX descriptor | ||
- | |||
- | > lsusb | ||
- | |||
- | ID 221a:0100 | ||
- | |||
- | Thoughts, Regs, Tom |