This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
en:software:compilation:compilation [2016/09/06 20:56] – [Compiling the EZ-USB FX2 firmware] stefan | en:software:compilation:compilation [2022/08/06 16:48] – [Compiling the EZ-USB FX3 firmware] 190.128.107.217 | ||
---|---|---|---|
Line 162: | Line 162: | ||
The standard rules for building the firmware using '' | The standard rules for building the firmware using '' | ||
the [[# | the [[# | ||
- | |||
- | ===== Compiling the EZ-USB FX3 firmware ===== | ||
- | The ZTEX SDK uses the Cypress EZ-USB FX3 SDK for compiling FX3 Firmware. Building process is the same. It is even possible to build the ZTEX firmware using the IDE delivered with the Cypress SDK (also see the [[en: | ||
===== Common pitfalls ===== | ===== Common pitfalls ===== | ||
- | ==== A binary (e.g. javac) cannot be found ==== | ||
- | **Solution: | ||
- | Make sure that configuration variables are set up correctly, see the [[en: | ||