Differences

This shows you the differences between two versions of the page.

--- en:ztex_boards:ztex_fpga_boards:high_speed_configuration [2012/05/15 18:29] – 84.181.62.168
+++ en:ztex_boards:ztex_fpga_boards:high_speed_configuration [2013/11/25 19:33] – stefan
@@ Line 1: / Line 1: @@
-====== High speed configuration of USB-FPGA Modules 1.15 ======
+====== High speed configuration ======
-USB-FPGA Modules 1.15, 1.15x and 1.15y support different configuration speeds:
+The following ZTEX FPGA Boards support different configuration speeds:
 ^ FPGA Board  ^ Low speed (via EP0)  ^ High speed (via bulk Endpoint)  ^
@@ Line 7: / Line 7: @@
 | [[http://www.ztex.de/usb-fpga-1/usb-fpga-1.15x.e.html|USB-FPGA Modules 1.15x]]  | 0.6 MByte/s  | 1.4 MByte/s  |
 | [[http://www.ztex.de/usb-fpga-1/usb-fpga-1.15y.e.html|USB-FPGA Modules 1.15y]]  | 0.6 MByte/s  | 24 MByte/s (using the CPLD) |
+| [[http://www.ztex.de/usb-fpga-2/usb-fpga-2.16.e.html|USB-FPGA Modules 2.16]]  | 0.6 MByte/s  | 24 MByte/s (using the CPLD) |
 The high speed configuration mode requires an bulk output Endpoint. Two macros must be called in order to enable the feature:
@@ Line 31: / Line 32: @@
 If ''ENABLE_HS_FPGA_CONF'' is not defined low speed configuration (about 0.6 MByte/s) via Endpoint 0 is used.
-Additional details about the CPLD on USb-FPGA Modules 1.15 can be found in the [[http://www.ztex.de/usb-fpga-1/usb-fpga-1.15.e.html#cpld|Configuration booster CPLD]] section of the products page.
+Details about the CPLD (including source code) can be found on the products pages of the FPGA Board that support it.