This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
en:ztex_boards:ztex_fpga_boards:standalone [2016/09/15 08:02] – [Standalone Firmware for the EZ-USB FX3] stefan | en:ztex_boards:ztex_fpga_boards:standalone [2022/03/23 09:04] – [Hints for Vivado] stefan | ||
---|---|---|---|
Line 31: | Line 31: | ||
<code tcl> | <code tcl> | ||
set_property BITSTREAM.CONFIG.CONFIGRATE 66 [current_design] | set_property BITSTREAM.CONFIG.CONFIGRATE 66 [current_design] | ||
+ | set_property BITSTREAM.CONFIG.SPI_FALL_EDGE Yes [current_design] | ||
set_property BITSTREAM.CONFIG.SPI_32BIT_ADDR No [current_design] | set_property BITSTREAM.CONFIG.SPI_32BIT_ADDR No [current_design] | ||
set_property BITSTREAM.CONFIG.SPI_BUSWIDTH 2 [current_design] | set_property BITSTREAM.CONFIG.SPI_BUSWIDTH 2 [current_design] | ||
- | set_property BITSTREAM.GENERAL.COMPRESS true [current_design] | + | set_property BITSTREAM.GENERAL.COMPRESS true [current_design] ;# (optional) |
</ | </ | ||
+ | |||
{{indexmenu_n> | {{indexmenu_n> | ||